Desoldering Station with Pneumatic Pump

This CS Station is equipped with the MV-A Pneumatic Pump and the comfortable DS360 Micro Desoldering Iron. Clean and dry compressed air is required.

The DS360 Iron works with C360 cartridges and allows desoldering the smallest plated through hole components and removing solder from surface mount pads.

The Station comes with the JBC exclusive Heating System and the intelligent sleep & hibernation features.

Using the menu you can personalize over 20 parametes.

It incorporates a USB connector (type B) to update station software and create graphs.

A complete Cleaning System with antisplash membrane and wiper with sponge is integrated.

100 V - Ref.

120 V - Ref.

230 V - Ref.

Selectable parameters
180 to 450 ºC / 360 to 840 ºF
Special features
These modes lower soldering tip temperature when the tool rests in the stand in order to avoid oxidation and extending tip life.
Max. and min. temperature:
Limit the temperature range in which the operator is allowed to work.
Temperatue levels
Instant selection of up to 3 editable temperature settings for solder joints with different heat requirement.
PIN protection
Keep station parameters protected against unauthorized access.
90% / 680 mmHg / 26.8 inHg
Flow rate
Software PC / Firmware update
Equipotential bonding
ESD safe
Tip to ground resistance
<2 ohms
Power supply
Peak power
40 W - 23,5 V
Voltage (AC)
ref. CV-1E - 120 V
ref. CV-2E - 230 V
ref. CV-9E - 100 V
Ambient operating temp.
10 to 40 ºC / 50 to 104 ºF
Dimensions and weight
Control Unit
150 x 175 x 145 mm / 4.0 kg
5.9 x 6.9 x 5.7 in / 8.82 lb
495 x 295 x 255 mm / 4.96 kg
19.5 x 11.6 x 10 in / 10.94 lb
Control Units:
CV with tip cleaning system
Follow us:
Copyright © 2011 JBC S.L. | Legal Notice | Privacy Policy | Terms and Conditions | Cookie policy | Site Map | RSS Feed | JBC Store | Contact Us