You are ready to start a soldering job: PCB and electronic components are clean and free from any contamination; you have a good quality solder flux; the most efficient tip has been chosen… but suddenly realize that oxidation has appeared due to an incorrect maintenance of the tip and the equipment.
What can you do to remove it? Just follow these steps according to the amount of rust!
After three days and with a meaningful upswing in attendance, productronica China drew to a close on the 16th March.
JBC has gained visibility and strengthened its presence at this electronics fair since 2012. productronica China has given the company the chance to find out how the SMT equipment could meet the changing needs of the Chinese manufacturing industry.
Within its growth strategy in the Asian country, the company is also exhibiting for the first time at the next Nepcon South China, which will be held on 29-31 August at the Shenzhen Convention & Exhibition Center.
During the three-day exhibition visitors who approached the JBC stand talked with our soldering experts and experienced our new solutions live. We’ve saved some of the best scenes from our crowded booth to share with you!
IPC APEX EXPO 2017 is a three-day event like no other in the printed circuit board and electronics manufacturing industry. JBC is ready for the show that begins today 14th February at the San Diego Convention Center in San Diego, CA. Stop by booth 715 to experience our new soldering solutions live!
You can also attend our technical sessions on IPC standards and rework applications given by Martin Garcia, an experienced IPC trainer who recently joined the company.
Want to know more about him? Read on!
JBC exhibits at the IPC APEX EXPO 2017 that takes place at the San Diego Convention Center in San Diego, CA on February 14-16.
Take a virtual tour of our booth even before the show begins! Receive valuable information in advance about our latest innovations so you can optimally prepare for your visit.
Experience JBC virtually by tapping the image 👇
In most cases, the factor that most influences the duration of a tip is the working temperature.
Before the ROHS regulation (Restriction Of Hazardous Substances) came into effect on the 1st July 2006, solder wire that contained lead was permitted. After this date the use of lead was prohibited (as well as other substances) in all equipment and processes except the following: medical apparatus, monitoring and surveillance equipment, measuring instruments and equipment specifically designed for the military and space industry as well the car sector (car control systems, airbags, etc.), rail transport, etc.
The special characteristic of the most common lead alloys is that the fusion occurs at around 180°C. With the most common lead-free alloys this happen approximately at 220°C. So the difference of 40°C meant it was necessary to increase the temperature of the solder tool to achieve a solder joint in the same length of time (if soldering time is increased, then the components and the printed circuits may be damaged) and this reduced the life of the tips and increased oxidation.